Installs like a ball. Except you need to hold the thread at end with a wrench. Make sure you are square and use the correct wrench or you will round it. Then you will need vise grips hint if you slip with wrench use vise grips. The base at where the sleeve that moves up and down this base will "unscrew" then the spring and the holding balls will fall out. You can put back together with patience. The base and the thread bolt are the same. Make sure it is snug before it is installed then hold the thread bolt. Hint keep the locking pin in hitch and keep pin on opposite side of tractor. So, you can keep an eye on thread bolt from spinning. Use washer and Lockwasher then nut. Tighten good and snug no extensions you will over torque and snap bolt. Snug it and step away from the hitch. Add lock tight if you feel better on doing so. Getting this part in your blades, well would make for a bad day. Have fun. Remember if it falls off it is not the parts fault. Get someone to install if your not mechanically inclined. Use the brain.
Installs like a ball. Except you need to hold the thread at end with a wrench. Make sure you are square and use the correct wrench or you will round it. Then you will need vise grips hint if you slip with wrench use vise grips. The base at where the sleeve that moves up and down this base will "unscrew" then the spring and the holding balls will fall out. You can put back together with patience. The base and the thread bolt are the same. Make sure it is snug before it is installed...
more
Pros: Durable, Easy To Use, Fast, High Quality
